Parallel Fences

---

These Parallel Fences are available for various machines, Felder, Hammer, Martin, Minimax, SCMI, just to name a few. Please contact us if you don't see one to fit your machine. 

Parallel Fences mount on the edge of the sliding table and allow you to set the distance very accurately, allowing for parallel or angled cuts, especially on narrower parts that would be hard to locate against just the crosscut fence.

We have revised the parallel fences with the addition of a linear rail to get a very smooth and accurate movement. Unit comes with self adhesive tape measure to be fit to your specific machine.

Pricing is as Follows for each fence (not a pair):

Retrofit Kit for Older fences to Linear Rail Fences              $375 @

Felder F-channel, P-channel (X-roll), and Hammer            $750 @

Martin, Minimax (certain models), SCMI (some models)    $850 @

Note: Prices do not include shipping

The DRO Versions of the Parallel Fences are available to fit the same range of machines as the Analog versions. The advantage of the DRO version is to be able to set the fences exactly to position within .001" or .01mm, and get repeatable accuracy with great speed. These units are also fit with a precision linear rail, and the magnetic banding is installed ready to use.

There are also many parameters than can be adjusted in the electronic unit to allow for Absolute or Incremental dimensions, step and repeat, automatic zeroing and many other possibilities.

Pricing is as Follows for each fence (not a pair):

Retrofit old DRO to Linear DRO                                            $445 @

DRO Retrofit, upgrades an Analog Linear Version               $600 @

Felder F-channel, P-channel (X-roll), and Hammer            $1300 @

Martin, Minimax (some models), SCMI (some models)      $1400 @

Note: Prices do not include shipping